a4s2.dll

Company
n/a
Decription

SFG MFC Application

Version
1.0.0.1
Architecture
32 bit
Threat Score
0 %
Original size
277 Kb
Download size
129.9 Kb
MD5
0a8994c6e622dc77ca23a7773549eab5
SHA1
e93796cc2c7356b8a2919055b02a01631aef653a
SHA256
968c1876f289bff58fc458313fccad4a675814afab4c5c730a27a9cfcfb9455b
#Unable to load mail system support.

#Unable to read write-only property.#Unable to write read-only property.

Cannot start scanning !

Could not start print job.

Data transfer failed.9Communication error (sending failed).

Destination disk drive is full.5Unable to read from %1, it is opened by someone else.AUnable to write to %1, it is read-only or opened by someone else..An unexpected error occurred while reading %1..An unexpected error occurred while writing %1.

ERROR !

Error or Warning

Miss Calibration Data !)Please take following calibration steps: @1. Select one of following two methods to calibrate the scanner:E   (a) If you have the specific calibration paper, put the scanner on1       the tray and insert the calibration paper.F   (b) If you have no calibration paper, remove the scanner out of theG       tray and put it on a blank paper that is wider than the scanner.(2. Click START to calibrate the scanner.B3. If the warming up dialog appeared after you click START, please

Please check the cable.+Scanner is not warmed up, please try again.8Note ! Scanner is not connected. Please check the cable.

Communication error (receiving failed).

Run-time error 

Last update: 07/13/2017