A2A QC disabled - start looking for cm CAmos::ModemControl RKCTL_SET_VOICE_AMPLIFYING_SCALE error - min > max - disabling ERROR - TxExtraDataSize buffer cannot contain all extra buffer !!! StartTxExtraDataSave ** ERROR ** Client not found StartUseTxExtraData ** ERROR ** Client not found StopUseTxExtraData ** ERROR ** Client not found StopUseTxExtraData ** ERROR ** not all data copiedback %d: Retrain initiated for Error Recovery in Training ** Start looking for CM_JM (in case QCA1 was missed) ** -> Start ErrInfo0 ---Symbol %d , Maximum Error = %d ALL/SCRDebug Client %s was unable to unregister because DBGSRVNT returned some ERROR ALL/SCRDebug Client %s was unable to unregister because constructor of KLowerDevice failed ALL/SCRDebug Client %s was unable to unregister because he failed to allocate KLowerDevice ALL/SCRDebug Client %s was unable to unregister due to wrong IRQL Abort - start bit Amos, ERROR - Modulation faied to Digest extra samples!!! Amos, ERROR - Tx Underrun size larger than max. invalid samples generate!!! Amos::** ERROR ** failed TxExtraBufferOnLine Amos::RxTxCb - ERROR RxLSamples = %d Amos::dpSetupDataPump - FATAL ERROR - unknown DataPump type Bit 17 start %d CMD Start Reneg CMD Start Retrain Cannot start Quick Connect CrystalTest::Calculate Error %f Data-Start Mse : %f dB (Trn-Data: %f dB) ERROR - RKCTL_RENEG: Modem not in Data - can't Reneg ERROR - calling ExtraReadCallBack while using extra Tx Data ERROR - failed to Alloc m_TempBuff ERROR - failed to Init AnsDet ERROR - failed to Init AnsGen ERROR - failed to Init CSyncV21Rx ERROR - failed to Init CSyncV21Tx ERROR - failed to Init ToneDet ERROR - failed to Init ToneGen ERROR - failed to Reset AnsDet ERROR - failed to Reset AnsDet - A2A ERROR - failed to Reset AnsGen ERROR - failed to Reset ToneDet ERROR - failed to Reset ToneGen Error in Phase4 while in ClearDown. Disconnecting %d JTAG detection enable %d MP detection enable %d Np enable %d PeakToAvgSqrError %f RequiredBitsInARowForDataStart = %d Residual Error Power: %f dBm Retrain Start -> A or B Retrain initiated for Error Recovery %d Retrain initiated for Error Recovery in Training %d Rx: Enable Adapt All Circuits due FRED NORMAL Rx: Enable Adapt All Circuits due INIT ADAPT @ 1200 Rx: Enable Adapt All Circuits due INIT ADAPT @ 2400 Rx: Enable All Circuits due INIT Rx: Enable All Circuits due INIT ADAPT @ 2400 Slot #%d : Final Error = %f Slot #%d :Gain = %f[dB],Encoding Law = %d,Error = %f Standard Deviation of Error %f Standard Deviation of Error entering data - %f Start At Data: %d Start At Data: buffer size %d is too small Start Close Start DATA event Start Fax DATA event Start Init Start InitParams Start PCM symbol state %s, samp %d, sym %d Start QAM symbol state %s, samp %d, sym %d Start V8bis DATA event Start bit %d = %x Start looking for INFOmh %d silence %d tone %f Start monitoring %s, Polarity = %d, Handle = 0x%p, UserData %p Start sample state %s in %d StartExternalEventMonitoring - Can't start monitoring HANDLE_ANY while monitoring a specific handle StartExternalEventMonitoring - Can't start monitoring specific while monitoring HANDLE_ANY SumError %f frames %d